|
Features |
 |
8 Channels 12 bit analog input
|
|
|
2 Channels 12 bit analog output
|
|
|
16 digital I/O
|
|
|
PWM Output
|
|
|
32 Bit pulse counter input
|
|
|
RS-485 interface 9600-115.2K
|
|
Back to Top |
|
Specifications |
| Temperature Range: 0°C to +70°C |
| Software: Free Easy-to-Use
Software!, Interface Tools for Visual Basic, Visual C++, and Test Point. |
| Analog Input Channels: 8 single ended or 4 differential, Software
selectable |
| A/D Converter: Linear Tech LTC1296 12 Bit |
| Analog Inputs: -5V to +5V, Unipolar and bipolar. Software selectable |
| Linearity Error: LTC1296BCN ± 0.012% (± 0.5 LSB) |
| Gain Error: ± 0.012% (± 0.5 LSB) |
| Offset Error: ± 0.17% |
| Temperature Drift : 100 ppm/°C ( max. ) |
| Analog Output Channels: 2 Channels 0V to +5V |
| D/A Converter: LTC 1448 12 Bit |
| D/A Specs: DNL ± 0.5LSB Offset Error ± 15mv, Output Impedance 120 ohm,
Short Circuit Current 120ma max |
| Bandwidth: 486 SPS maximum, 115,200 baud, single channel |
| Digital I/O: 16 digital I/O lines (two 8 bit ports), I/O line data
direction is software selectable |
| Digital I/O Current: I/O line source/sink 25 ma, Total current 200 ma
for the 8 bit port |
|
Digital I/O Voltage Levels
|
|
Input Off (0) = 0V - 0.8V |
|
|
Input On (1) = 2.0V - 5.0V |
|
|
Output Off (0) = 0.6V max. |
|
|
Output On (1) = 4.3V min. |
|
| PWM Output: PWM Freq.: 1.8KHz - 430KHz, PWM duty: 0%-100% |
| Pulse Counter: Input 1 MHz max. input rate, 32 bit counter capture,
Counter increments on high-low transition |
| Communications: RS-485 (8 data bits, no parity, 1 stop bit), 4000 feet up
to 255 Nodes |
| Baud Rate: 9600-115.2K BPS, DIP switch selectable |
| Command Protocol: Simple ASCII commands. See the User's Manual |
| Operating Power: 7.5 Vdc to 15.0 Vdc, 50 ma nominal, 450 ma max. |
| Accessories: 8 Channel analog I/O, 2 Channel analog with instrument
amps, Analog I/O DB15 Terminal board, Digital I/O DB25 Terminal board,
Digital I/O Board for Opt Iso modules. |
|
Back to Top |
